Prev

Next

What are the wireless connection technologies of the... Internet of things (iot) applications have been deeply rooted in our lives. The E-Lins H685 industrial-grade router is a small industrial-grade wireless router with single or double LAN ports. TDD/ fdd-lte, 4G, 3G, GPRS network optional. Besides, what are the wireless connectivity technologies for the Internet of things?   1....

更多文章

The use of industrial wireless routers Industrial-grade wireless router adopts high performance 32-bit industrial-grade ARM9 communication processor, which is widely used in finance, electric power, postal, water conservancy, environmental protection, meteorology and other industries.   Industrial router is mainly used in intelligent transportation,...

更多文章

Cascade and stack of industrial-grade 4G routers The most basic star Ethernet architecture, the actual star enterprise network may be much more complex than this. This renaturation is not only reflected in how high-end network equipment, how complex configuration, more importantly, the performance of network switching level is more complex. Industrial routers and firewalls...

更多文章

The difference between 4G router and 4G DTU 4G industrial wireless router and 4G DTU are also used for wireless network data transmission of industrial equipment. But there are also significant differences between the two, and the differences between the two are mainly from the appearance of the interface, the use of methods and the application environment.   1....

更多文章

Characteristics and differences between RS485 and RS232 RS232 and RS485 have always been the weak current common interface, but there are a lot of people do not understand the difference between them is not very thorough.   I. overview of RS485   RS-485 serial bus is widely used when the communication distance is tens of meters to thousands of meters. RS-485...

更多文章

twitter

TDD LTE and FDD LTE’s Advantages / disadvantages of for cellular communications

文章目录 : 技术相关

Let’s talk something about TDD LTE and FDD LTE’s Advantages / disadvantages of for cellular communications.

As we know, the LTE mainly covers two types, which are TDD and FDD. There are a number of the advantages and disadvantages of TDD and FDD that are of particular interest to mobile or cellular telecommunications operators. These are naturally reflected into LTE.

COMPARISON OF TDD LTE AND FDD LTE DUPLEX FORMATS
PARAMETER TDD LTE FDD LTE
Channel reciprocity Channel propagation is the same in both directions which enables transmit and receive to use on set of parameters Channel characteristics different in both directions as a result of the use of different frequencies
Paired spectrum Does not require paired spectrum as both transmit and receive occur on the same channel Requires paired spectrum with sufficient frequency separation to allow simultaneous transmission and reception
Hardware cost Lower cost as no diplexer is needed to isolate the transmitter and receiver. As cost of the UEs is of major importance because of the vast numbers that are produced, this is a key aspect. Diplexer is needed and cost is higher.
UL / DL asymmetry It is possible to dynamically change the UL and DL capacity ratio to match demand UL / DL capacity determined by frequency allocation set out by the regulatory authorities. It is therefore not possible to make dynamic changes to match capacity. Regulatory changes would normally be required and capacity is normally allocated so that it is the same in either direction.
Guard period / guard band Guard period required to ensure uplink and downlink transmissions do not clash. Large guard period will limit capacity. Larger guard period normally required if distances are increased to accommodate larger propagation times. Guard band required to provide sufficient isolation between uplink and downlink. Large guard band does not impact capacity.
Cross slot interference Base stations need to be synchronised with respect to the uplink and downlink transmission times. If neighbouring base stations use different uplink and downlink assignments and share the same channel, then interference may occur between cells. Not applicable
Discontinuous transmission Discontinuous transmission is required to allow both uplink and downlink transmissions. This can degrade the performance of the RF power amplifier in the transmitter. Continuous transmission is required.

 

发表评论

You must be logged in to post a comment.